[Geomoose-users] Using Identify

[Basques, Bob (CI-StPaul)]

It does seem to be broken. . . .highlighting of the poly should at least happen on the click . . . I wonder if the click response is being munged up . . .

bobb

-----Original Message-----
From: Geomoose-users <geomoose-users-bounces at lists.osgeo.org> On Behalf Of Brent Fraser
Sent: Thursday, May 28, 2020 9:29 AM
To: GeoMoose Users <geomoose-users at lists.osgeo.org>
Subject: [Geomoose-users] Using Identify

Think Before You Click: This email originated outside our organization.


Hi all,

   So how do I use Identify in GM 3.x?  Using demo on the GeoMoose site,
I:

 1. Click Identify
     - the  Super Tab contains "Draw Point" checkbox and confusing "Close"
and "Go" buttons, which I ignore
     - map pane now has a  "End Drawing" (button?)

 2. Click the center of a parcel
     - Super Tab shows:
         Error: No valid selection geometry

 What am I doing wrong?

 Best Regards,
 Brent Fraser





_______________________________________________
Geomoose-users mailing list
Geomoose-users at lists.osgeo.org
https://lists.osgeo.org/mailman/listinfo/geomoose-users