Dear Dr. Kroeger,

I found this message of yours in the mail-archive. I was searching for some
clues to my digitizer problems. I had a Altek AC40 hooked up to a Data
General, it died last week while it was moved. Now I'm trying to run GRASS
with a Calcomp 9100. Unfortunately there is no manual for the digitizer. I
found a little documentation in the GRASS source code, but It was not of
very much help. I could not find a format file for it. I was also wondering,
if the only way to change the settings is to take it apart in order to get
to the dip switches?. I am very frustrated with this problem, I've been
working on it for two days now and am running out of Ideas. I would
appreciate if you could help me with this.

Stefan Jaeger				currently at
Dept. of Geography			USGS	
University of Heidelberg		National Center
INF 348					Reston, VA 22092
69120 Heidelberg			USA
Germany
stefan@geo0.geog.uni-heidelberg.de	sjaeger@resdgs2.er.usgs.gov


> 
> 
> We have a CalComp 9100 series table that has proved very reliable and is
> supported by Grass. At the time we purchased, three years ago, CalComp had
> a very aggressive academic discount which allowed us to buy a much nicer
> table than we thought we could afford.
> 
> 
> Glenn C. Kroeger, Ph.D.
> Associate Professor of Geology
> Director of Environmental Studies
> Trinity University, 715 Stadium Dr., San Antonio, TX 78212
> (210) 736-7607
> gkroeger@geology.trinity.edu
> 
> 
> 


