Greetings,

	I am using GRASS 4.1 and I am having a very bad time getting a simple DXF file into raster form.  I have seen comments on this bulletin board regarding this problem, but they have not been of use.

	I have a ONE polygon file, digitized in UTM in .DXF format.  I brought it into GRASS fine, and I can display it.  When I use v.to.rast after v.support, I get a blank map.  V.support tells me that one label is unattached.  

	I ran this whole process through ascii files so I could keep tabs on what's happening.  My ascii file looks good.  I created an ascii file in the dig_att directory.  It had one line, correct format, with x,y coordinates right in the middle of my polygon.  I have compared the ascii files to ascii files from the GRASS sample data set, e.g. the quad boundaries, that do go from ascii to vector, to raster, and they SEEM to be the same.  Why won't v.support recognize my area label?  

	Any hints would be most appreciated.

	Replies can be sent directly to me at garyo@hdyroqual.com.


  



