Greetings All - <br>
<br>
I have been using different parameters for tension and smoothing to best approximate the contours provided to me.<br>
<br>
Using a tension of 50 and a smoothing of 5, I as able to produce a
pretty close approximation to the input data on two foot
intervals.&nbsp; To validate the interpolation occuring between the 2
foot contours, I created 1 foot contours to visualize what was occuring
between the 2 foot contours. The input data contours were more
conceptual than practical at this stage, so it is given that the input
surface is not for exact interpretation.<br>
<br>
The following webpage
(<a href="http://mseibel.googlepages.com/v.surf.rast-tuning">http://mseibel.googlepages.com/v.surf.rast-tuning</a>) shows the input and
output results.&nbsp; 1) original 2 foot contours 2) interpolated 1
foot contours 3) input and interpolated data overlaid.&nbsp; <br>
<br>
This particular area is conceptualizing a stream valley.&nbsp; What
parameters might I tune in order to get the resulting interpolated
contours between the input data to have a similar shape as the contours
that follow the 2 foot input contours?<br>
<br>
Meaning that the output 1 foot contours, which are on 2 foot intervals
approximate the data fairly well, with a &quot;bell shape&quot; for the stream
valley, but the intermediate 1 foot contours between the 2 foot contour
data is rounded out too much, and doesnt preserve the same &quot;bell shape&quot;
as approximated on the output 2 foot contours.&nbsp; Basically I would
like to replicate the shape of the 2 foot interpolated contours through
the surface to the next 2 foot contour to keep the stream valley as
smooth as possible.<br>
<br>
What parameters should I be tuning to get the desired results mentioned above?<br>
<br>
Thanks,<br>
Mark<br>