<pre>Hi Devs, <br /><br />Forget about my rumblings of yesterday (see below)<br /><br />The problem is worse:<br /><br />- Open a three-band raster into QGIS. It is displayed OK.<br />- Open the raster properties window and bang, the three bands (RGB) are set to Band 1. Resulting in a grey coloured raster if user click either Apply or OK.<br /><br />Is that on purpose?<br /><br />Regards,<br />Benoit<br /><br /><br />Original message:<br />"""<br /> With QGIS 1.7 release r15056 on WinXP Pro. <br /><br /> I have a three-band raster (geotiff) loaded and it displays all-right. Then<br />&nbsp;I open the raster properties window, go to the transparency tab, slide<br />&nbsp;the transparency ruler and click Apply. The transparency is applied to the<br /> raster but the three bands (R,G,B) are all set to band 1 resulting in a<br /> black&amp;white (grey) raster! <br /><br /> The same behaviour is observed when I add a transparent pixel and click<br />&nbsp;Apply... <br /><br /> Can someone confirm these behaviours? <br /><br /> Regards, <br /> Benoit<br />"""<br /></pre>