<div dir="ltr"><div>Hi,</div><div><br></div><div>My employer is on QGIS 3.10. I have an issue with the "avoid overlap setting" when digitizing. I would like to avoid overlap only "within" the current layer, but not for all layers. Also, it would be desirable to have "avoid overlap" affect only some specific layers, and others not.<br></div><div><br></div><div>Currently, when I turn on "Avoid overlap" on a single layer, it has an effect on all layers, which is often not the desired behavior.</div><div><br></div><div>I see that <a href="https://github.com/qgis/QGIS/pull/35689">https://github.com/qgis/QGIS/pull/35689</a> (already in 3.16 or master) addresses the case of "avoid overlaps" on active layer only, but it still doesn't allow the user to have a configuration to only affect specific layers - it always affects all other layers.<br></div><div><br></div><div>How much work would it be to add a new mode where I can select specific layers that are affected by the avoid overlap setting? The advanced configuration doesn't cover this so far. It is an all or nothing choice.</div><div><br></div><div>I know it is a bit complicated to allow arbitrary combinations of layers that affect each other or not, but the alternative is that the user digitizing would constantly have to change settings while digitizing, which is also quite annoying and error-prone (if forgotten).<br></div><div><br></div><div>Thoughts?<br></div><div><br></div><div>Thanks,</div><div>Andreas<br></div><div><div><div dir="ltr" class="gmail_signature" data-smartmail="gmail_signature"><div dir="ltr"><div><br>--<br>Andreas Neumann<br></div><a href="http://QGIS.ORG" target="_blank">QGIS.ORG</a> board member (treasurer)<br></div></div></div></div></div>