<div dir="ltr">Hello Everyone,<div><br></div><div>I apologize in advance if this question is a bit basic, but I am very stuck here. I am plotting a 900 point archaeological scatter, and those 900 points were all taken as distances and angles from a transit. The exact easting and northing of the transit was not taken from the field, but I do have multiple other given GPS points. So, I should be able to get the location of the transit from the vertex of two lines drawn back from the GPS points, and then be able to plug in the 900 points (artifact locations) based on that.</div><div><br></div><div>So the question is, how do I plot the unknown point (transit location) based on two or more known points for which I have an easting, a northing, a distance from the unknown, and the angle from the unknown?<font face="arial, helvetica, sans-serif"> And second: once I have the transit location, how would I calculate and plot those other points as a batch, based on their distances and angles from the transit, instead of inputting them individually?</font></div><div><font face="arial, helvetica, sans-serif"><br></font></div><div><font face="arial, helvetica, sans-serif">Thank you so much in advance for any answers you are able to provide, it is much appreciated.</font></div><div><font face="arial, helvetica, sans-serif"><br></font></div><div><br></div><div>Regards,</div><div>Nathan Garrett</div><div>Fisher Archaeological Consulting</div></div>