Hi<div>I was wondering if QGIS could be used in a slightly different way. </div><div><br></div><div>I do EMPA ( Electron probe micro-analyzer ) of microscope slides. When it is in the device I can note down x,y,z co-ordinates when taking a photo or doing a sample analysis. The problem is when you remove the slide and put it back in again these previous x,y and z components are now meaningless because the device that holds the slide is not accurate enough to achieve the same positioning again. I was thinking that if I had known reference points on the slide I could "geo-reference" all pictures and scans I did for a specific session and then when I have follow up photos and point analysis data, taken in a separate session, I could "geo-reference these and use QGIS to map out all the photos and pin point analysis as different layers making it very easy to correlate data. As long as I have the co-ordinates I should then be able to add any other microscope ( eg. petrographic images ) data as a separate layer and match it up.</div>
<div><br></div><div>If I could get it working I could also write a plugin that could tell me co-ordinates of a point on the "map" based on the new x,y co-ordinates when I re-insert the microscope slide. </div><div>
Just in case it is not clear let me explain:</div><div>When I insert a slide into the EMPA machine a certain spot will have co-ordinates of 255,234,40. When I re-insert the slide it might now have co-ordinates of 100,2000,80. However it is still the same point but because I am measuring in nano meters small changes can make big differences.</div>
<div><br></div><div>My question is thus, does this sound possible and have anyone else done something similar? The area being mapped is actually flat and I am not sure if that would make a difference.</div><div><br></div>
<div>Regards<br clear="all"><div><br></div>-- <br>Gerhardus Geldenhuis<br>
</div>