<div dir="ltr">I am trying to clip some layers from Ordnance Survey vector  files with QGIS 2.6.1 on Ubuntu 14.04LTS running in Virtual Box running on WIN7.<div><br></div><div>I have these OS layers, which cover a far bigger area than I want to work with</div><div><br></div><div>ST_SurfaceWater_Area</div><div>ST_Woodland </div><div>ST_Land</div><div>ST_SurfaceWater_Line</div><div>ST_Road.</div><div><br></div><div>I created a new polygon layer called Clip, and added a rectangular polygon on this layer that extended over the area I wanted to clip.</div><div><br></div><div>The three Polygon layers clipped as expected, but with the line layers I just get a blank shape file.</div><div><br></div><div>I have converted the two line layers from multipart to singlepart</div><div><br></div><div>I have checked that all layers are EPSG"27700-OSGB 1936/National Grid, by double clicking on the layer and reading what the CRS is set at. I have  switched off the Project level "Enable on the fly CRS transformations and all layers stay aligned.</div><div><br></div><div>I created two new shape  layers using WGS84 one for the "clip" layer and a new STsurfaceWater_line layer, just to see if it was something to do with the CRS, but they didn't work either.</div><div><br></div><div>I have tried using one of the clipped layers and the intersect command to clip the line layers but that just gives me the same blank shape file.</div><div><br></div><div>I have waited until the "OK" in the clip dialog box becomes active again after a clip, to give the clip operation time to complete.</div><div><br></div><div>Continued searching just gives advice that repeats what I have already found and tried.</div><div><br></div><div>Can anyone suggest what I might be doing wrong.</div><div><br></div><div>Thanks,</div><div><br></div><div>Graham</div><div><br></div><div><br></div></div>