<div dir="ltr"><div>Hi everybody,</div><div><br></div><div>I wonder if someone in this community/forum can explain me what I am going to describe.</div><div><br></div><div>1 - I have an "ecw" raster file with a CRS already defines as "EPSG 102091" (Monte_Mario_Italy_1). I have create a polygon (I have set the parameter CRS as "EPSG 102091" too) and I use it as a mask to clip a portion of the raster through "GDAL Clip raster by mask layer". Then I saved this portion of the raster as a new file. When I open the clipped raster, the CRS is not "EPSG 102091" anymore but "EPSG 3003" that, of course, is always a Monte Mario (exactly "Monte Mario / Italy zone 1") but I wonder why is not "EPSG 102091" also in the portion I have clipped. What disturd me is also that these two RS are not exactly the same, as also stated here:</div><div><br></div><div><a href="http://gis.stackexchange.com/questions/102541/any-difference-between-epsg3003-and-epsg102091">http://gis.stackexchange.com/questions/102541/any-difference-between-epsg3003-and-epsg102091</a></div><div><br></div><div>Anyone can explain me why that happens?</div><div><br></div><div>2 - Maybe here is not the place for this question, but I try... I have converted the previous portion in EPSG 3003 into a common WGS84 ("EPSG 4326") through GDAL Warp (reproject) and, looking at the new raster, it seems that the tool performs the operation properly. Sorry, this portion is located in the middle of Sardinia. Then I create a kmz file through "Create Garmin cusrom map from map canvas" tool, I imported this file (in the proper file extension and with the proper CRS, wgs84) in the Garmin BaseCamp but my area is not where it should supposed to be, Sardinia, but is between Albacete and Madrid, in Spain (yes, BaseCamp view is set in wgs84), any idea?</div><div><br></div><div>Thanks in advance,</div><div><br></div><div>Filippo</div></div>