<div dir="ltr"><br><br>On Thu, Jun 5, 2014 at 5:51 PM, Moritz Lennert <<a href="mailto:mlennert@club.worldonline.be">mlennert@club.worldonline.be</a>> wrote:<br>> On 02/06/14 20:15, Markus Neteler wrote:<br>>><br>
>> Hi,<br>>><br>>> as general improvement I would like to see that each map generating<br>>> GRASS command prints the name(s) of the generated maps. This is<br>>> especially relevant when multiple maps can generated (e.g. r.watershed).<br>
...<br>>> wondered if a more<br>>> generic possibility exists at library level.<br>...<br><br>[as written, that example was *ugly*]<br><br>> Sounds quite verbose to me. Why do we need this ? Maybe make this<br>
> conditional to --verbose ?<br><br>Dunno. Example - this I got from a user:<br><br><br><font face="courier new, monospace">v.vol.rst -c input=utm3d@UTMfinish wcolumn=temp tension=10. cvdev=cvdevmap38 maskmap=ter@UTMfinish segmax=698 npmin=699 dmin=150.0 zmult=50.0<br>
6283 records selected from table<br>Processing all selected output files will require 0 bytes of disk space for temp files<br>WARNING: Points are more dense than specified 'DMIN'--ignored 5938 points (remain 345)<br>
WARNING: 345 points given for interpolation (after thinning) is less than given NPMIN=699<br>WARNING: There is less than 700 points for interpolation, no segmentation is necessary, to run the program faster, set segmax=700 (see manual)<br>
bitmap mask created<br>Percent complete:<br>Finished interpolating<br>Building topology for vector map <cvdevmap38>...<br>Registering primitives...<br>334 primitives registered<br>334 vertices registered<br>Building areas...<br>
0 areas built<br>0 isles built<br>Attaching islands...<br>Attaching centroids...<br>Number of nodes: 334<br>Number of primitives: 334<br>Number of points: 334<br>Number of lines: 0<br>Number of boundaries: 0<br>Number of centroids: 0<br>
Number of areas: 0<br>Number of isles: 0<br>The number of points in vector map is 6283<br>The number of points outside of 2D/3D region 0<br>The number of points used (after reduction) is 345<br>(Sat May 31 11:09:50 2014) Command finished (26 sec)</font><br>
<div><br></div><div>... he told me that nothing got calculated (apparently he didn't use g.list).</div><div>Indeed the information is quite buried in above output. Also r.watershed with multiple output does not say much.</div>
<div><br></div><div>That's why I would see the generated map names printed out.</div><div><br></div><div>Markus</div><div><br></div></div>