help selecting mapsets

[W. Fredrick Limp]

Simon,

It is possible to do this... the SCS version of GRASS allows
users to "move" from one to another location.  The key is
in GIS.sh.  You can revise GIS.sh so that the basic section
is in a do while loop and that the monitor is released only
when you fully exit.  Basically you have to start the
while loop before the call to $ETC/gis_set and need to move the 
g.gisenv MONITOR= statement to BRFORE the loop starts
you end the loop before removing the lockfile.  

This is from memory -- if there is an SCS type they can 
post the GIS.sh for us all...

> 
> but wouldn't it be nice to be able to change *locations* without exiting grass
> ... ?
> 
> Simon Cox
> 
> ----
-- 
W. Fredrick Limp,   Director                     FAX: (501) 575-3846
CAST, Center for Advanced Spatial Technologies   TEL: (501) 575-6159     
12 Ozark Hall, University of Arkansas         
Fayetteville AR 72701                             fred at cast.uark.edu