[mapserver-users] Legend: Calling one of two layers shows both legend entries
Brent Fraser
bfraser at geoanalytic.com
Tue Jul 28 18:29:53 PDT 2009
Nils,
Sounds like a GeoMoose problem; you might try asking their email list.
I seem to recall a similar problem with GeoMoose 1.6.1; try using
underscores (_) instead of a dash (-) in the layer name.
Best Regards,
Brent Fraser
> Dear all,
> I am using a mapfile with two layers.
>
> When using Geomoose 2 as client and turning the first of these layers on
> from the legend, the respective signature will appear in the legend at
> its respective location (as expected), but also the legend location of
> the second layer.
>
> I tried using STATUS ON / OFF at layer level - but no success. How can I
> change this? I added two screenshots for clarification. Mapbook snippets
> are below.
>
> When calling the legend via URL in my browser, there is no such problem:
> http://host/cgi-bin/mapserv?map=/srv/coffeeshop/map/conservation.map&mode=legend&layer=LAYER-01&layer=LAYER-02
> shows both legend signatures
>
> http://host/cgi-bin/mapserv?map=/srv/coffeeshop/map/conservation.map&mode=legend&layer=LAYER-01
> shows only the signature of LAYER-01
>
> Any hints on that?
>
> Thanks,
> Nils
> --
> Center for Development Research
> Department of Ecology and Resource Management
>
> Walter-Flex-Strasse 3
> 53113 Bonn (Germany)
>
> Tel.: +49 (0) 228 - 73-1793
> FAX: +49 (0) 228 - 73-1889
>
> E-Mail: coffee at uni-bonn.de
>
> Web: http://www.cofis.info/atlas
> http://www.coffee.uni-bonn.de
> _______________________________________________
> mapserver-users mailing list
> mapserver-users at lists.osgeo.org
> http://lists.osgeo.org/mailman/listinfo/mapserver-users
>
More information about the MapServer-users
mailing list