[OpenLayers-Users] WMSGetFeatureInfo request to geoserver too sensitive

[Ismail, Mark]

I am using openlayers 2 and issuing a WMSGetFeatureInfo request to geoserver

It works fine but It is far to sensitive to where you click - if you don't get right in the centre of a point or icon it finds nothing, it can take 2 or 3 attempts to get a response even if clicking carefully and zoomed in

Is there any way to make that click "less sensitive" so it will pick up the closest point  to the mouse click ?

Mark Ismail

This e-mail and any attachments are confidential. It may contain privileged information and is intended for the named recipient(s) only. It must not be distributed without consent. If you are not one of the intended recipients, please notify the sender immediately and do not disclose, distribute, or retain this email or any part of it and do not take any action based on it.

Unless expressly stated, opinions in this email are those of the individual sender, and not of Knowsley MBC. Legally binding obligations can only be created for, or be entered into on behalf of, Knowsley MBC by duly authorised officers or representatives.

Knowsley MBC excludes any liability whatsoever for any offence caused, any direct or consequential loss arising from the use, or reliance on, this e-mail or its contents. We believe but do not warrant that this e-mail and any attachments are virus free. You must therefore take full responsibility for virus checking and no responsibility is accepted for loss or damage arising from viruses or changes made to this message after it was sent. Knowsley MBC reserves the right to monitor and/or record all e-mail communications through its network in accordance with relevant legislation.
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.osgeo.org/pipermail/openlayers-users/attachments/20141010/c1c0f73c/attachment.html>