<div dir="ltr">Hi,<div><br></div><div>I am using QGIS 2.18.2 on a Mac and new to QGIS (or much of GIS), but I would like to get a specific task done and I am not sure if I ran into a fundamental limitation of QGIS.</div><div><br></div><div>As I tried to describe on <a href="http://gis.stackexchange.com">gis.stackexchange.com</a>, I would like to produce shape files for US census block groups (CBGs) but separately for each (or the few largest) commuting zone (CZ).</div><div><a href="http://gis.stackexchange.com/q/227420/28426">http://gis.stackexchange.com/q/227420/28426</a><br></div><div><br></div><div>CBG shape files are available state by state, but the commuting zone is not an attribute in the Census files.</div><div><br></div><div>Yet if I join a layer of a shape file with another layer with CZ identifiers, I can only filter the result to get a virtual layer, which does not export the geographies if exported/saved. See a separate question specifically on that:</div><div><a href="http://gis.stackexchange.com/q/227277/28426">http://gis.stackexchange.com/q/227277/28426</a><br></div><div><br></div><div>I am aware of some limitations of the QGIS architecture that might cause this.</div><div><a href="https://hub.qgis.org/issues/8141">https://hub.qgis.org/issues/8141</a><br></div><div><br></div><div>However, maybe there is a common workaround which I haven't found. Or anything else you can think of but I could not.</div><div><br></div><div>Thanks for any help,</div><div><br></div><div>Laszlo</div></div>