[GRASSLIST:4253] Re: v.in.dxf in 5.7

[Michael Barton]

Is there any way to set this module up so that we can compile it without
having to compile all of GRASS 5.7? This would be useful for other modules
also. Perhaps it is impossible as it uses to much general GRASS source code.
But if not, this would be nice.

Michael

On 8/25/04 5:02 PM, "Hamish" <hamish_nospam at yahoo.com> wrote:

>> How can i import an dxf file in grass 5.7, i was trying but i
>> didn't find it in the gui. ¿console?
> 
> 
> You need to compile GRASS with DWG support and use v.in.dwg.
> 
> This requires downloading a library from the internet which you can not
> redistribute.
> 
> 
> see
> http://freegis.org/cgi-bin/viewcvs.cgi/*checkout*/grass51/vector/v.in.dwg/desc
> ription.html?rev=HEAD&content-type=text/html
> 
> 
> 
> Hamish

____________________
C. Michael Barton, Professor
School of Human Diversity and Social Change
PO Box 872402
Arizona State University
Tempe, AZ  85287-2402
USA

Phone: 480-965-6262
Fax: 480-965-7671
www: <www.public.asu.edu/~cmbarton>