[MapProxy] Problem with custom projections

[Guillaume Sueur]

got it dudes !
QGis doesn't like bboxes with miny=-90 and maxy=90. I just set it 
manually to -89 and 89 int the xml template and it went well.

But please Oliver, tell me where to set that globally !

Thanks

Guillaume

Le 16/12/2010 16:04, Guillaume Sueur a écrit :
> I guess it depends whenever I start or stop paster...
>
>
> Le 16/12/2010 15:51, Rahkonen Jukka a écrit :
>> Hi,
>>
>> My QGis 1.6 gives me an error: empty capabilities document. With
>> OpenJUMP I can connect but your server tends to give http 503 error
>> when I use EPSG:2154. With EPSG:4326 I can see at least the OSM layer.
>>
>> -Jukka Rahkonen-
>>
>>> -----Alkuperäinen viesti-----
>>> Lähettäjä: mapproxy-bounces at lists.osgeo.org
>>> [mailto:mapproxy-bounces at lists.osgeo.org] Puolesta Guillaume Sueur
>>> Lähetetty: 16. joulukuuta 2010 16:46
>>> Vastaanottaja: Oliver Tonnhofer
>>> Kopio: mapproxy at lists.osgeo.org
>>> Aihe: Re: [MapProxy] Problem with custom projections
>>>
>>> That's what I did, using a local shapefile to know where to
>>> go to. But
>>> no request is sent, as if the layer bbox wasn't covered by the wms
>>> layer, which is wrong as the 4326 bbox exposed by MapProxy is
>>> the whole
>>> world extent.
>>> It works OK with ArcGIS who doesn't care for what is written in
>>> getCapabilities and just sends a request for each view
>>> displayed. It's
>>> ok too with an OpenLayers sample configured for using the EPSG:2154.
>>> There must be something in the Capabilities which makes Qgis
>>> believe the
>>> layer is not there, but I can'tfigure out what yet. I'm gonna
>>> investigate a little bit further now that I'm sure the
>>> service is OK in
>>> itself.
>>>
>>> Best regards,
>>>
>>> Guillaume
>>>
>>> Le 16/12/2010 14:35, Oliver Tonnhofer a écrit :
>>>>
>>>> On 16.12.2010, at 14:11, Guillaume Sueur wrote:
>>>>> I'm trying to display a MapProxy cache using QGIS 1.6. The
>>> cache is SRS EPSG:2154. It never shows up under QGIS. I
>>> suspect something wrong in the getCapabilities, because no
>>> request is sent to MapProxy. But I didn't find what yet.
>>>>
>>>>
>>>> MapProxy does not advertise the BBOX for each supported
>>> SRS, only for EPSG:4326. The 'zoom to layer' function of QGIS
>>> can't handle that. You need to zoom to your map manually at
>>> the moment, and then you should see your map AFAIK.
>>>>
>>>> Regards,
>>>> Oliver
>>>>
>>> _______________________________________________
>>> MapProxy mailing list
>>> MapProxy at lists.osgeo.org
>>> http://lists.osgeo.org/mailman/listinfo/mapproxy
>>>
>>
> _______________________________________________
> MapProxy mailing list
> MapProxy at lists.osgeo.org
> http://lists.osgeo.org/mailman/listinfo/mapproxy
>