[Qgis-user] Configuring the OTB toolbox?

[Johanna.Botman at griffith.nsw.gov.au]

I get the following message when I try to run some of the algorithms under
the Processing tab.
"OTB folder is not configured. Please configure it before running OTB
algorithms."

Can someone point me in the direction to solve this? I can see that there
is no program path if I go into the config settings, but I am not sure what
I need to put in there.

 I have looked under Program Files | Dufour | to see if I can locate the
OTB toolbox, but to no avail.

_______________
Johanna Botman
GIS / Assets Officer

Griffith City Council
Ph: 02 6962 8168


Please consider the environment before printing this email notice.

--------------------------------------------------------------------
This e-mail, together with any attachments, is for the exclusive and
confidential use of the addressee(s. Confidentiality is not waived if
you are not the intended recipient. Any other distribution, use of, 
or reproduction without prior written consent is strictly prohibited. 
Views expressed in this e-mail are those of the individual, except 
where specifically stated otherwise. If this e-mail has been sent to 
you in error, please delete the e-mail completely and immediately from 
your system. Although reasonable precautions are taken, Griffith City 
Council does not warrant or guarantee this message to be free of errors,
interference,viruses or similar malicious code and does not accept
liability for any consequences to the recipient opening or using this
email or attachments.
This email was scanned and cleared by NetIQ MailMarshal and Norman AV
---------------------------------------------------------------------