[FOSS-GPS] (Basic) Minicom does not show correct Output
agstrydom at gmail.com
Thu Jul 10 06:33:00 PDT 2014
Turn Hardware flow control off, why are you running such high baud rates?
I find the receivers very stable and my results are excellent at 38400 baud
On Thu, Jul 10, 2014 at 3:21 PM, MichaelFerrero <dav.mercenary at gmail.com>
> I am having some troubles with minicom. I know its not as such a
> question but I do not know where else to ask this. I have attached my
> receiver ublox6T to my computer and is recognized by my device: its
> recognized at ttyACM0
> dmesg | grep tty
> [140624.449007] cdc_acm 2-1.3:1.0: ttyACM0: USB ACM device
> My output for stty -F /dev/ttyACM0 is as follows: Here I think there is a
> proble as why do I get undef for most of my values
> My settings are as follows for minicom and my terminal
> Then I do minicom -o -s and I get the following output
> While I should get an output like this:
> I just cannot get why I dont get the correct output. I have tried
> but I dont get where is the problem. Maybe I am missing something. Anyone
> else who had similar problems.
> View this message in context:
> Sent from the Open Source GPS-related discussion and support mailing list
> archive at Nabble.com.
> This message is sent to you from FOSS-GPS at lists.osgeo.org mailing list.
> Visit http://lists.osgeo.org/mailman/listinfo/foss-gps to manage your
> For more information, check http://wiki.osgeo.org/wiki/FOSS-GPS
-------------- next part --------------
An HTML attachment was scrubbed...
More information about the FOSS-GPS